Reboot and you will see an extra screen before WinXP boots as the Promise card is detected. Or, if I F6 and install the drivers and then just quit and re-boot, will XP see the drivers and use the controller? ADC offset error measurement 8. Setting labels for IDE devices is optional. Doesn’t this seem like something else is going on besides it looking for the wrong partition? Find More Posts by nmayotte. Want to know if that peripheral is compatible with Linux?

Uploader: Doshakar
Date Added: 5 October 2018
File Size: 12.4 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 24418
Price: Free* [*Free Regsitration Required]

This might work though don’t know for sure: Promisee labels for IDE devices is optional. Last edited by WhatsHisName; at Xt2 your drives to the cards and then boot into rescue mode using your installation media boot: If you have 2 IDE channels and only 1 is dead connect the boot drive to it and select it in BIOS as the boot drive disconnect the optical drives if the Promise drivers are on diskette.

Initial value depending on the input 6. Doesn’t this seem like something else is going on besides it looking for the wrong partition?


PROMISE ULTRA133 TX2 Series x86, x64 Windows Driver

It was running XP Home when it died. Open Source Consulting Domain Registration. Well, I want to move an existing boot drive to the new controller, but installing the drivers before moving the drive is out of the question. Are there any linux drivers for Intel GV Chipsets. Since its trying to boot from the sata drives, it really shouldn’t matter as far as booting goes where the ide drives are plugged into. At the grub screen try going into console mode. You will get a list of devices.

Promise TX2 controller and installation. Part and Inventory Search. RHEL4 is installed on those two sata drives, is it possible that they are conflicting with the drives I try to plug into the controller card? By joining our community you will have the ability to post topics, receive our newsletter, use the advanced search, subscribe to threads and access many other special features.

I purchased a Promise Ultra TX2 add on controller to replace the dead controller. Load the drivers for the promise card insert card first as per Promise instructions.

Promise Ultra 133 TX2 Driver

From there,i would head to recovery,press enter for password,then type: All times are GMT Join our community today! ADC offset error measurement 8. Changing a V capacitor in Cisco switch power adapter Registration is quick, simple and absolutely free.


You may find that you need to reorder your drives on the cards to move what you think is hd0 to the correct position. BB code is On. Any help will be welcome! And whe I do lspci it dectects both cards correctly.

Promise Ultra Tx2 PCI IDE Local Bus RAID Controller Card A | eBay

Lilo dual-booting problems L 99 The time now is If you need to reset your password, click here. For migrating an existing boot drive to the new controller, it says to install the drivers before disconnecting from the old controller. Redhat likes to use labels instead device nodes because it is easier for SCSI users to add new hard drives with out messing up promisr setup.

I was under the impression that this was possible.